prone to rock on their rubber mountings, particularly at idling speeds, have extra
or plain bars with rubber-bonded bushes at either end to hold them steady.
Cars with transverse engines, and a few others, have dampers - either plain
or a combination of both.
Check the dampers during major services, every 12,000 miles (20,000 km), or if you suspect that the
is moving abnormally. This may show as a thump when accelerating or braking, sometimes accompanied by excessive movement of the
Inspect the bushes for distortion, softness, perishing, cracking or oil contamination.
Try to move the bar by hand or with a lever. If it moves at all, one or both bushes may be faulty.
Remove the bar and
new bushes. On some cars the bushes are
and you have to replace the whole bar.
Unbolt the bar at both ends and remove it. Inspect the bar and its bolts and mounting points, to make sure they are not damaged, bent or rusted. Replace any doubtful parts.
Replaceable bushes are usually a simple push-in fit. Early Minis have metal cones which fit inside the bushes: press these in with a vice to make the bar easier to refit.
When refitting the bar, you may need to lever it into position while you tighten the bolts. Check a telescopic damper in the same way, but also look for signs of hydraulic leaks.
If you find a faulty damper, check the other engine mountings to make sure that the excessive movement has not damaged them.
Check also to see if the mountings have softened, cracked, perished or separated at the rubber-to-metal bond.
Replacing steady bar bushes
Open the bonnet, and remove any components that are in the way. Wipe the bar, its bushes and the mountings clean. Inspect the bushes by levering them upwards, this will reveal any cracks or deterioration in the rubber. Any excessive movement either upwards or sideways suggests a faulty bush. Renew as necessary.
Checking adjustable steady bars
Some steady bars are adjustable in length. Adjust the bar until there is no strain on it when the engine is in its normal position.
If the steady bar is adjusted so that it is too long or short, this will put a constant strain on the rubber bushes.
Hold the bar with self-locking grips and rotate it.
After adjustment it should be possible to just move the bar against the tension of the bushes. A service manual for the car may give a maximum and minimum length.
If you have to adjust it outside this range, probably the engine mountings are distorted or perished.
Some bars can be adjusted in place by loosening a locknut and turning the bar; others have to be unbolted at one end.
When you tighten the locknut, take care you do not twist the bushes.
Checking a telescopic damper
If for any reason you suspect that a telescopic damper is not damping properly - either that it has weakened or that it has seized solid - or if you suspect that it has leaked, remove it and test it in a vice the same way as a suspension damper.
Stop wasting time on YouTube and get serious!
The Ultimate Car Mechanics video course
Learn everything about modern cars from our new video series.
Almost all car engines work on the four-stroke cycle, so called because it
takes four strokes of the piston induction, compression, ignition and exhaust -
to produce one firing of the fuel/air mixture. This means that the crankshaft
rotates twice to complete each cycle.